Add a new layer and name it door.
Load from Disk > door.sel and floodfill with the same
wood pattern as the jamb. Apply this Inner Bevel:
now Selections > Invert > and apply
this Drop Shadow:
Deselect.
Add a new layer and name it door panels.
Load from Disk > door panels.sel Floodfill with the
same wood pattern as above. Go to Effects > 3
D Effects > Inner Bevel and apply this setting TWICE:
Deselect.
Add a new layer and name it stairsrail.
Load from Disk > stairsrail.sel and floodfill with
#CBB9A7. Go to Effects > 3D E
Effects > Textures > and apply the
granite2 texture with these settings:
Deselect.
Now I am sorry about this but the only way
I could get the stairs to turn out as good selections I had
to do them individually. There are 10 steps and you
can place them all on one layer. So add a new layer
and name it stairs. Load from Disk > stair1.sel and
open your pattern palette and find the pattern Cemented Rock
(it came with PSP 7) and use these settings:
and floodfill. Add an inner
bevel using these settings:
Deselect. Load from Disk >
stair2.sel and do the same as above and continue these steps
for all 10 stairs.
This is what you should have so far:
This
tutorial was created,
and is property of and © 2001 to JCW Designs